TESA M4P-3 interface module

Application

For connecting TESA inductive length-measuring probes. For converting standard TESA alternating voltage signals to analogue direct voltage signals, for integration in multi-point measuring equipment in controllers.

Execution

• Connect up to four TESA inductive length-measuring probes
• Output of analogue direct voltage signals with sensitivities of 1 V/mm, 2.5 V/mm, 5 V/mm or 10 V/mm. Zero point can be set at 0 V or 5 V
• Each channel can be individually set using jumpers
• Aluminium housing 155 x 75 x 40 mm
• Holder for 35 x 7.5 mm DIN top hat rails
• Direct voltage supply via 0 to +24 VDC, +/- 9 VDC or external power adapter
• Up to ten boxes can be supplied centrally via a voltage source.
• Direct connection of up to ten boxes via the front interfaces

Advantage

• Jumper configuration inside on the PCB. Protection against basic manipulation of the configuration from the outside
• Can be used flexibly for all inductive length-measuring probes with TESA check
• Can be integrated directly into switch cabinets via top hat rail installation and 24 V voltage supply

Notes

Do not connect TESA DC probes as this can destroy the electronics.